We recommend our aero-pick
modelling pins, Order No. 7855/02, for
use while you are building the boat.
Introduction:
The model should be assembled
following the sequence of the
stages of construction described in
these instructions. The laser-cut
components are individually
numbered. The manufacturing
method leaves small tabs on some
parts which have to be cut away
using a thin-bladed modelling knife.
The dark edges of the laser-cut
parts should also be rubbed off
using abrasive paper in order to
obtain sound glued joints. Check
that all components fit accurately,
and carry out any minor trimming
required before reaching for the
glue. Allow all glued joints to dry out
fully before starting the next stage of
construction. We recommend a
fast-setting waterproof white glue;
please take care to prevent
adhesive running onto the untreated
mahogany parts and any external
surfaces which will be visible on the
finished model, as the glue will show
up through the final painted finish.
We recommend that you apply a
coat of sanding sealer (Order No.
7666/02) to the mahogany
components before gluing them.
The whole of the boat - inside and
out - must be given several coats of
clear water-resistant boat lacquer
before the model is placed in the
water, as this waterproofs the wood
and the glued joints. If you have to
glue parts to areas which have
already been lacquered, use two-
pack adhesive for those joints.
Each of the cabin sides 23 features
two portholes, but only one of them
is shown in the drawings.
Order No.
3012/00
RC functions: Rudder,Sail position
Specification:
Length approx. 1200 mm
Beam approx. 280 mm
Mast height approx. 1370 mm
Displacement approx. 4700 g
Mainsail approx. 29.1 dm²
Jib approx. 14.8 dm²
Essential accessories:
Standard servo, rudder approx. 3 kg
Standard servo, sails approx. 8 kg
or sailwinch
Battery approx. 1000 mAh
Keel ballast Order No. 3012/10
Bellissima
This model is not a child's toy.
Adult supervision is required for
young persons under fourteen
years.
To Next Page
Need help?
General
