Need help?Do you have a question about the Aeronaut Pilot and is the answer not in the manual?
Details attaching the keel, chine stringers, and deck stringers to the hull frame assembly.
Guides on gluing stern formers and preparing/joining the hull side panels for structure.
Instructions for gluing hull sides to frames and attaching bottom panels to ensure structural integrity.
Guides on attaching shaft couplings, motors, and supports, and aligning the drivetrain components.
Details on fitting deck girders, battery/servo plates, and installing rudder bushes and the servo.
Instructions for fitting rudders, pushrods, servo, and installing cable tubes for searchlights.
Explains wiring LEDs with series resistors and presents a suggested circuit diagram for the lighting system.
Lists components for the lighting system, including LEDs, resistors for different colors, and lamps.
Step-by-step instructions for assembling the 20mm searchlight, including bending, soldering, and fitting components.
To Next Page
General
