15
18
19
17
16
Glue former R5 at right angles into servo tray R4
and glue former R8 at right angles into R7.
Check with set square or similar.
Glue reinforcements for tailplane slot R13 and R14 to
fuselage side. Temporarily insert former R11 into fuselage
side as an end stop.
Cut off two 375 mm and two 225 mm long pieces of 8×8 mm
triangular stock R15.
Place triangular stock on building board as shown and use a razor saw
to make cuts at intervals of 15 to 20 mm over a length of 200 mm.
This will make the triangular stock easier to bend when you glue it to
the fuselage side.
Place right fuselage side R1 A on flat
building board and secure with pins.
Insert former R2 and assembly R3, R4, R5
in fuselage side. Do not glue!
Glue in place wing saddle R12 and make
sure contour matches contour of fuselage
side perfectly. Remove any excessive glue
from slot in R12.
Glue servo tray into former R3 at
right angles.
R5
R4
R3
R13
R14
R15
R11
R8
R7
R2
R12
R3, R4, R5
R1 A
To Next Page
Loading...
