To Next Page
A
anna40Aug 9, 2025
What to do if the Aerotech Industrial Equipment collet chuck will not close?
- TTerry BrayAug 9, 2025
If the collet chuck on your Aerotech Industrial Equipment won't close, first ensure that the stage is receiving sufficient air pressure and that there are no blockages in the supply line. The pressure should be adequate. Air should be supplied to only one input at a time, either 'Collet Chuck Open' or 'Collet Chuck Closed'. Also, check that the collet is fully threaded in by following the procedures in Section 2.8.
General
