ENGLISH
16
While the blade set is removed, you can use the
cleaning brush to remove residual hair from inside the
appliance.
Cleaning the appliance
¾ Clean your appliance occasionally with a damp cloth,
then wipe it dry.
Cleaning the charging contacts
If the charging contacts 7 on the appliance or the charg-
ing contacts 3 on the charging unit are dirty, charging
may not be possible or may be interrupted.
¾ Clean the contacts using a cloth or wad of cotton
wool soaked in alcohol or spirit.
Care of the NiMH rechargeable battery
To maintain the charging capacity of the battery we rec-
ommend occasionally draining the battery until the mo-
tor stops.
If the battery is run down (motor stops), be sure to
switch the On/Off switch to 0 and place the appliance
in the charging unit.
¾ Make sure you do not leave the appliance switched
on when putting it aside if the battery is run down.
¾ Make sure the appliance is switched off (On/ Off
switch to 0) when you place it in the charging unit.
6. What should I do if ...
… the appliance will not switch on?
¾ Is the battery low? Plug in the mains adapter for the
charging unit and charge the trimmer.
¾ Is the blade set dry? The blade set must be oiled. Pro-
ceed as described on page 15.
… the blade set “sticks”?
¾ The blade set must be oiled. Proceed as described on
page 15.
To Next Page
Loading...
