AEV STARGATE
Futurcom Srl via della Tecnica 35, 40050 Argelato Bologna ITALY
29
The LTN code is found in this board, Location Table Number, together with the SID Service
Identifier, plus the setting of the coverage area, which can be considered as an identification
code of the sender, similar to the PI.
All parameters required for the event description are provided in the following board.
Let’s see the board.
The Location parameter is used to establish where the event has occurred.
The Event parameter establishes the type of event.
The Duration parameter establishes how long the event lasts presumably.
The Direction parameter establishes the direction in which the event has occurred.
The Extent parameter establishes additional specifications concerning the place in which the
event has occurred.
The Diversion parameter establishes alternative routes.
The Repetition parameter establishes the repetition percentage of this compared to the other
events pointed out.
The last board available in this program is called Edit Group. This function is normally disabled
as it allows the transmission percentages of the groups to be altered. Therefore, if unsuitable
modifications are made, there is the risk that the information is not transmitted correctly.
Proceed as follows to enable this function: save the configuration file "nome.rds" with a
Notepad text editor. Open the "nome.rds" file. Type-in On, in the EnableGroupFunction=Of f
item.
Then save the file and open it again using the Open command from the main window of the
program.
Do not make any other modif icat ions in this f ile, otherw ise er rors may be produced in the
program.
To Next Page
Loading...