AFi LISA C200V - Page 49

PROCEDURE AP2.002
SOFTWARE PROGRAMMING
Notice Originale - Rev.1.4 Manuel Maintenance – Lisa / Loreena 1/ 3
Microcontroler software update
Step 1 : Switch Off the centrifuge & connect the
electronic control unit "Ogive" to PC.
(*) Use VCP cable if no compatible port on PC
Step 2 : Start "Flash Loader" on PC
Flash Loader ressource :
http://www.st.com/web/en/catalog/tools/
FM147/CL1794/SC961/SS1533/
PF257525?s_searchtype=keyword
Connexions to PC
Connection parameters
Flash
loader
demons
(*)VCP
cable