When the blinkers are ON, signs will be lit (5.3 and / or 5.4).
When the Half Speed switch (1.2) is at Half Speed position, a sign of "1/2" is
lit (5.11).
When there is one of the follows conditions: Motor Overheated, Panic Brake
was operated or Manual release brake is in OPEN position or electric EMB
is opened, the Alarm indicator will be lit (5.13).
The LCD screen digital area will show the speed of the scooter. (5.12). The
speed is shown in units of kph or mph. Set up of the speed units can be
done by technician.
The MODE / RESET button (5.20) will change the digital reading from Speed
to Travel Distance or Time. The distance is showed in units of Km OR Miles
and the time is showed in Hours.
(Note: Set up of the Distance units can be done by technician.)
When you push the MODE bottom to the modes: "travel time" and "travel
distance" and keep pushing it more than 7 seconds , the "travel time" and
"travel distance" will reset to Zero.
The Set Up button 5.21 is used to setup the Clock.
When changing to clock mode with MODE bottom , keep pushing for 7
seconds and you will get into the Set Up mode of the clock.
Clock Adjust:
Use combine Left SETUP bottom and Right MODE bottom as follows:
Every push on Mode change different time unit and this unit is Flashing.
When Flashing , every push on Setup increase 1 unit.
Save of Updated Time and
Date
To Next Page
Loading...
Need help?
General
