1. Insert first the Charging Plug (8) to the Charging Socket (9) located at the
right side of the tiller box.
2. Plug the power cord (10) of the charger into a wall outlet (11).
3. When charging is completed and you are ready to go - unplug the charger
cord (10) from the wall outlet (11) and then remove the charger plug (8) from
the Breeze S charging socket (9).
4. In ideal storage conditions, batteries which were charged to full capacity
and are not used should be recharged every 6 months.
5. If you are planning not to use your Breeze S for an extended period of
time, we recommend charging it for two days and then disconnecting the
batteries.
6. If you have not used your Breeze S for an extended period of time,
charge the batteries for at least 24 hours before driving.
Note: There is NO need to disconnect the Charging Plug promptly
after the charging is complete.
However, DO NOT leave the Charger connected to the batteries
FOR MORE THAN TWO WEEKS.
As long as the Charging Plug is in the Charger Socket, the
electronic control of the Breeze automatically cuts all power to the
electric system and the Breeze Sannot be driven.
The charger supplied is suitable for charging Lead Acid Dry/Gel
batteries .Only the defind type of charger should be used. Using
any other type of charger should be approved by your Dealer /
Supplier.
To Next Page
Loading...
Need help?
General
