Afreda S6 - Troubleshooting and Solutions; Motor Not Working; Insufficient Range Per Charge; Charger Not Charging

3
Troubleshooting and Solutions for Afreda S6 E-Tricycle:
Symptom
Possible Cause
Solution
Motor not
working when
powered on
Poor speed control
Replace speed control
Faulty brake disconnect switch
Replace brake disconnect switch
Damaged motor
Replace motor
Faulty controller
Replace controller or consult a
repair center
Loose connectors
Check connectors
Insufficient
range per
charge
Low tire pressure
Inflate tires to the recommended
pressure
Insufficient battery charge or charger
malfunction
Ensure sufficient charge or check
for poor charger connection
Aged or damaged battery
Uphill terrain, strong winds, frequent
braking and starting, overloading, etc.
Replace the battery
Observe under normal road
conditions
Charger not
charging
Loose connection between charger
and battery port
Securely fasten the plug and
connectors
Battery pack's internal connection
wires disconnected
Weld the connection wires
Charger malfunction
Replace the charger
Speed control
malfunction
Poor speed control
Replace speed control
Loose connectors
Check connector
Low battery voltage
Charge the battery to sufficient
voltage
*If the issue persists, please contact our customer support for assistance from professional
technicians. (afredabikeservice@outlook.com or service@afredabike.com)
Safety Guidelines for Afreda S6
Dear valued user, for your safety and the safety of your family, please read and adhere to the
following guidelines:
Section 1: User and Dealer Restrictions
Prohibit unauthorized wiring and modifications to Afreda S6 structure and performance,
including alterations to battery configurations, boosting, changing wiring, increasing bulb
wattage, and adding audio systems.