***Warning: All wires should avoid friction and contact with sharp metals. Wires should be
securely fastened to Afreda S6 frame, and no exposed wires are allowed.
Maintenance and Repair:
1．Newly purchased Afreda S6 should be well-adjusted. Regular maintenance and care
are essential for daily use.
2．In general, spoke adjustment should be done after riding for a certain period (about
half a month) to ensure the wheels are aligned.
3．Regularly check the tire pressure to maintain normal usage conditions.
4．Major components such as handlebars, seat posts, saddles, axles, wheels, frames,
pedals, folding axles, folding seats, rear pedals, and screws should be regularly inspected and
adjusted to ensure smooth movement. Tighten any loosened nuts and screws promptly. All
screws are treated to prevent loosening. If a few screws become loose, remove and clean them,
then apply anti-loosening glue (typically anaerobic glue 243).
5．Brake oil pipes and control cables are fixed in a specific position when Afreda S6
leaves the factory. If any detachment is found, repair it promptly to prevent the pipe or cable
from breaking during folding. Ensure proper tightness during fixation, guaranteeing smooth
folding/unfolding of Afreda S6.
Charger Usage, Maintenance, and Precautions:
How to Charge:
a. Use the corresponding charger provided by Afreda; otherwise, it may affect the battery's
lifespan or lead to accidents such as combustion.
b. When charging, disconnect the output system of Afreda S6, close the throttle lock, and
try to charge the battery fully in one go.
To Next Page
Loading...