© Copyright LOTRONIC 2014 FOG COLOR RGB Page 3
can also take out the liquid bottle and fill in the fog liquid outside the unit.
The fog machine must be installed on the ground. It’s not allowed to slope the unit or place it upside down
After use, switch the fog machine off and unplug it from the mains
The fog machine isn’t waterproof. If moisture or fog liquid enters inside the machine, you must unplug it immediately
from the mains and contact your dealer.
It’s forbidden to spray directly towards persons. Keep far away from flammability and explosive objects
The fog spray is very hot, please keep a distance of at least 5 meters when using it
Please don’t touch the surface of the fog machine during the use because the housing will reach 40-80°C
When the machine doesn’t work, please check if the fuse is burnt out or not. If it is, replace it by an identical fuse,
find out the fault and restart the machine. But please note: the repair must be handled by professional.
INSTALLATION INSTRUCTIONS
You can use the fog machine in two situations: Floor (horizontal or vertical use) and suspended use (reverse
position ).
Floor use :
Note : if you use the FOG COLOR RGB in horizontal fog jet, follow instructions closely to avoid tank spills.
- Before deciding on a location, always make sure there is easy access to the product for maintenance
and fluid replacement
- The rubber feet also serve as floor supports. When mounting the product on the floor, make sure that
the product and cables are away from people and vehicles.
Note : To avoid spillage with any mounting, always position the fluid tank with the tank’s cap in the
upper most position above the tank’s fluid line.
To Next Page
Loading...
Need help?
General