EasyManua.ls Logo

AGA DxD 910 - Dispenser Control; Control Centre Power down

AGA DxD 910
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Water Filter Settings
When the water lter indicator light is illuminated this means
the water lter should be changed.
After the water lter is changed, press the Water Filter RESET
button (Fig.2-16) – the water lter indicator light will go out.
Note: If the water lter illuminator light does not go out
when the RESET button is pressed then try the following:
Make sure the freezer is in Quick Freeze mode, then press and
hold the EXPRESS FRZ and the RESET buttons (Fig.2-17) for
3seconds. The water lter indicator light will go out.
Closing and Opening the Water Supply to the
Ice Maker
To close the water supply, press and hold the freezer button
> and refrigerator button < simultaneously for 3 seconds
(Fig.2-18). The ‘EXPRESS FRZ’ indicator will ash.
This will shut o the water supply to the ice maker but will
not aect the water dispenser.
To re-open the water supply, simply press and hold the
freezer button ‘
> and refrigerator button < simultaneously
simultaneously for 3 seconds again (Fig.2-18). The ‘EXPRESS
FRZ’ indicator will stop ashing, indicating that water is once
again available to the ice maker.
Dispenser Control
The Dispenser Control panel (Fig.2-19) is situated on the
front of the left-hand door.
To Lock
Press and hold the
ArtNo.030-0029 - DxD symbols
‘ button (Fig.2-20). When the buzzer
sounds the lock indicator will light – the clock settings are
now xed and the cold drinks dispenser is locked.
To Unlock
Press and hold the
ArtNo.030-0029 - DxD symbols
‘ button (Fig.2-20). When the buzzer
sounds and the indicator light goes out the dispenser is
unlocked. The clock settings can now be adjusted and the
cold drinks dispenser can be used.
Adjusting the Clock
Press and hold both the
‘ button and
ArtNo.030-0029 - DxD symbols
‘ button for three
seconds (Fig.2-21). After the buzzer sounds the digital
display will icker and the clock can now be set. Press the
button to adjust the hours, and the
ArtNo.030-0029 - DxD symbols
‘ button to adjust
the minutes.
Note that it is a 12-hour clock.
Control Centre Power Down
After 30 seconds the digital display on the control panel will
switch o until such time as the refrigerator is used again.
ArtNo.600-0014 - Dispenser control
88:88AM
D AB
C
ArtNo.600-0041 - Dispenser control lock
88:88AM
Fig.2-19
Fig.2-20
A – Hour button,
B – Minute button,
C – Lock button,
D – Digital display
Fig.2-17
ArtNo.600-0043 - Water supply settings
Fig.2-18
ArtNo.600-0040 - Freezer controls 3
Fig.2-16

Related product manuals