‘ button
(Fig.2-21) until a bleep sound is heard.
The clock is now set. To revert to the energy saving setting
simply repeat the procedure.
Note: If power to the refrigerator is interrupted the display
will return to the default mode.
Using the Water Dispenser
When using the water dispenser for the rst time you may not
get water out immediately since air will be in the line. Please
press the dispenser tab for at least 1 minute, to clear the air
and replace it with water from the water tank.
The rst few cups of water will be warmer than the remaining
cups. This is normal.
• Do not use a paper cup or one that is too tall to fit into
the dispenser cavity.
• When dispensing water please keep your cup under the
spout for a few seconds after finishing operating the tab
to catch all the water droplets.
• If the dispenser has not been used for a while, throw
away the first 5 cups of water to remove any impurities
in the lines.
Error Codes
In the event of an error occurring, the main control digital
display screen will show one of the following codes:
F1, F2, F3, F5, F6, Ed, ER, ES, E0, E1, E2.
If this happens, please contact Customer Service to have the
refrigerator repaired.
Door Ajar Alarm
If any door is left open for more than 60 seconds the Door
Ajar Alarm function will start. An alarm will buzz at 30-second
intervals to alert the user that a door has been left open.
Over-voltage Protection
This refrigerator is equipped with power-surge protection.
When this function is in eect, the refrigerator will switch o
automatically. After 5 minutes, the power should be turned
back on.
Power-breaking Memorising Function
When the refrigerator turns o as a result of a power surge,
the state of the refrigerator before the power break is
memorised. Once restarted, this allows the refrigerator to
operate with the programmed default values as before the
power break.
To Next Page
Loading...
