AGA Ludlow User Manual (English)

Questions and Answers:

L
lwalshJul 27, 2025
What to do if my AGA Ludlow Stove appliance turns off and will not turn on?
- J
  Jason PhamJul 27, 2025
  If your AGA Stove appliance turns off and refuses to turn back on, there are several possible causes. First, the appliance may have overheated, causing the thermal switch to disconnect. To resolve this, turn off the main switch, allow the appliance to cool down for 10 minutes, and then turn it back on. Another possible cause is a tripped house circuit breaker; in this case, reset the house circuit breaker. Finally, the appliance's fuse may have blown, requiring you to replace the fuse.
D
David MilesAug 1, 2025
Why is my AGA Stove appliance not coming on when the switch is flipped to ON?
- A
  April WalkerAug 1, 2025
  If your AGA Stove appliance doesn't turn on when you flip the switch to ON, there could be a few reasons. First, make sure the appliance is properly plugged into an electrical outlet. If it is, the appliance may have overheated, causing the thermal switch to disconnect. In this case, turn off the main switch, let the appliance cool down for 10 minutes, and then turn it back on. Finally, the circuit board might be burnt out, requiring inspection and replacement if needed.
T
Tracey JohnsonAug 5, 2025
What to do if the ember bed in my AGA Stove is not glowing or is dimming?
- R
  Rebekah RangelAug 5, 2025
  If the ember bed in your AGA Stove is not glowing or is dimming, it's likely that the ember LEDs are burnt out. Inspect the ember bed LEDs and replace them if necessary.
D
Dylan ValdezAug 9, 2025
How to fix dim or no flame in AGA Ludlow?
- D
  Douglas HallAug 9, 2025
  If you notice a dim or no flame in your AGA Stove, there are a couple of potential causes. First, the flame LEDs might be burnt out, so inspect them and replace if needed. Alternatively, the back black cloth might be falling off and rolling the flicker; in this case, replace the flicker and back black cloth.
A
Andrew Mccann PhDAug 14, 2025
Why is the remote control for my AGA Stove not working?
- M
  Michael JohnsonAug 14, 2025
  If the remote control for your AGA Stove isn't working, it might be due to low batteries or the unit switch being in the “O” position. Try replacing the AAA batteries in the remote control and ensure the switch is in the “I” position.
C
Carl KnoxAug 17, 2025
Why is no warm air coming out of my AGA Ludlow appliance?
- B
  Barry HigginsAug 18, 2025
  If no warm air is coming out of your AGA Stove appliance, it's possible that the heater is burnt out. You should inspect the burner and heater assembly and replace it if necessary.
S
Sarah BaileyAug 22, 2025
How to fix flame sputtering in AGA Ludlow?
- J
  jacobwardAug 22, 2025
  If the flame sputters in your AGA Stove, the flame motor may be defective. Call a qualified service technician to replace the flame motor.