Assembly Instructions
Step 7:
Step 8:
Place the jump mat (G) with
attached enclosure on clear
ground inside the frame.
Make sure the 2 warning decals
align with 2 T-joints!
You may want to use gloves for this step! Before you begin, make sure each
V-ring has been threaded through the holes on the enclosure net. Make sure the
enclosure door is lined up with a T-joint. Using the spring tool, hook the smaller
end of a spring into the V-ring just left of the enclosure door. Stretch the free end
of the spring until it reaches the frame hole just left of the T-joint.
Page 11 of 22
To Next Page
Loading...
