Assembly Instructions
Step 15:
Step 16:
If you want, take a snack
break because you’re
MORE THAN HALFWAY
DONE, and you deserve it.
This next step is easy. Just
slide all the straight tubes
(K) and curved tubes (J)
into foam (L). If you’re
having trouble getting the
foam over the tubes, try
adding a small amount of
water inside the foam!
Insert one straight tube (K) into one curved tube (J), and secure with one
self-tapping screw (X). Important: On the curved tube there is one end that has
two holes. Make sure that end is on top!
Repeat this step to attach the 5 remaining straight tubes and curved tubes
together.
Page 15 of 22
To Next Page
Loading...
