AGFA ELANTRIX 95 S - General Information

English
6
GENERAL INFORMATION
MACHINE DESCRIPTION
Plate processors: ELANTRIX 95 S /125 S/
150 S form part of the latest generation of
automatic machines.
These machines permit enhanced
performance whilst at the same time ensuring
considerable savings in terms of materials and
electricity.
Plate processors: ELANTRIX 95 S /125 S/
150 S fully automatically develop, wash, gum
and dry plates.
Plate processors: ELANTRIX 95 S /125 S/
150 S are made using top quality materials,
which are specified above normal design
standards so as to ensure exceptional
durability throughout the lifetime of the
equipment.
The technical features of these machines,
which are the best currently available on the
market, are as follows:
• Grey PVC tank;
• EPDM rubber rollers with stainless
steel pins;
• Side casing made of fibre-glass;
• Painted steel structure;
• Plexiglas lids.
The electronic system permits the control of
all functions in a quick and accurate manner.
With the possibility of optical fibre connection
and data exchange simply using a PC, to
ensure a high degree of interaction and
facilitates possible future software upgrades.
The appearance has been chosen to render
these processors both practical and pleasing to
the eye. Special care was taken in the
elimination of all projecting parts which may
hamper normal operations.
The central unit of the process consists of a
single-section frame made of PVC. All the
other components, such as the rollers, tanks,
electrical system, motors, pumps, lids support
parts, actually rest against the frame itself.
The upper part of the processor is fixed to the
support by means of four bolts, allowing easy
separation of the two parts.
DEVELOPER SECTION
The plate is developed by means of immersion
with a pump that keeps the liquid in circulation
and which is also filtered.
There is a thermostat device, which controls
the temperature in the developer tank.
The automatic replenishment system and a
closure lid also ensures the long life of the
developer.
Any excess developer is collected in an
external container by means of an overflow
system.
Always ensure that the developer recovery
container is never too full.
Regularly empty the drum.
WASHING SECTION
There are two drilled pipes, positioned across
the tank which sprinkle water on the upper and
lower part of the plate to ensure it is thoroughly
cleaned.
GUMMING SECTION
Two further rollers are located over the pair of
rubber rollers, one has a velvet cloth in contact
with the rubber roller and one in stainless steel,
which is partially immersed inside a tank in
which the finishing product circulates.
The finishing product may be either gum or
thermal gum according to specific needs.
There is a pump for liquid circulation.
DRYING SECTION
The plate is dried on both the top and bottom.
The air temperature is regulated by means of
the electronic control device.