Troubleshooting (cont.)
The flash doesn’t work.
◗ The flash may be turned off. Check the flash setting.
◗ The batteries may be too weak. Replace them.
The recorded image is blurry.
◗ You or the subject may have moved while you were taking the picture. Hold the camera
steady and take the picture again.
◗ You may have moved the camera before the image was captured. Hold the camera steady
and take the picture again.
The recorded image is too dark.
◗ There may not be enough light. Set the flash to the Auto or Forced setting.
◗ The subject may be too far away for the flash. The flash illuminates subjects up to a dis-
tance of only about 8.5 feet (2.6 m).
◗ Use PhotoWise to adjust the brightness and contrast of your image (see the .pdf file
PhotoWise Tips
or on-line help in PhotoWise itself).
39
39
To Next Page
Loading...
