AGFA Jeti Tauro H3300LED Series - Startup and Shutdown

Jeti Tauro H3300LED Operator Manual
17
Agfa Graphics
Chapter 3
Pedals
The Jeti Tauro H3300 LED features three pedals on the Media Input side and three pedals on the output
side, both with identical functions. These pedals duplicate GUI controls over the printer in order to ease
the loading process.
Fig.3-2: Pedals
Fig.3-3: Pedal GUI Controls
- The functions of the pedals differ depending on the status of the printer. The conditions shown in
Table Gui controls, apply for each table.
Table Gui controls
GUI Controls:
Status Le pedal Control pedal Right Pedal
Ready Turns vacuum on/o - Transports the me-
dia drive belt toward
- Press this pedal a
second time to stop
the belt
- Continued pressure
on the pedal is mov-
ing the belt until you
li your foot
- Transports the media
drive belt backward
- Press this pedal a
second time to stop the
belt
- Continued pressure
on the pedal is moving
the belt until you li
your foot
Preparing Turns vacuum on/o Slot 2: Up/down
movement in manual
sheet mode
Print start
Printing Disabled Disabled Disabled
Revision 1.0