Agilent Technologies 5000 Series - Page 7

7
Agilent 5000 Series
If you did not try Lab 1:
Press Save/Recall and
Default Setup to ensure the
scope is in an initial known
state. Press Trigger mode
and switch from Auto to
Normal triggering.
Press Autoscale
on the scope.
Using the Horizontal
Time/Div knob, adjust
the timebase to isolate
one rising edge
(100 ns/div).
Over a period of 10 seconds, count how many times you
see the glitch appear?
Using the
Intensity knob,
adjust the wave-
form intensity
to 100%.
Now you can
isolate the glitch
using a Pulse
Width trigger.
Tektronix TDS3000B Series
If you did not try Lab 1:
Press Save/Recall,
Recall Factory Setup and
OK Confi rm Factory Init.
to ensure the scope is in
an initial known state.
Using the Waveform
Intensity knob on
the front panel,
adjust the waveform
intensity to 100%.
Press Autoset.
Using the Horizontal
Scale knob, adjust
the timebase to
100 ns/div.
Over a period of 10 seconds, count how many times you
see the glitch appear on the signal?
Using the
Vertical Scale
knob, adjust the
volts/div to
500 mV/div.
Using the Vertical
Position knob, move
the waveform down
by approximately 2
divisions to better
fi t on the screen.