Agilent Technologies InfiniiVision 5000 Series User Manual

Agilent Technologies
Agilent InfiniiVision
5000/6000/7000
Series Oscilloscopes
User’s Guide

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Channels	2 or 4
Form Factor	Benchtop
Waveform Update Rate	Up to 1, 000, 000 waveforms per second
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse Width, Pattern, CAN, LIN, FlexRay, I2C, SPI, USB
Interface	USB, LAN, GPIB (optional)
Operating Temperature	0 °C to +50 °C

Summary

1 Introduction

2 Initial Setup

Package Contents

Power Requirements

Specifications for voltage, frequency, and power consumption of the oscilloscopes.

Verifying Basic Oscilloscope Operation

Using the Analog Channels

Information on connecting and using analog input channels.

3 Connecting to the Device Under Test

Connect the Probes to the Oscilloscope

Steps for physically connecting probes to the oscilloscope channels.

Compensating Passive Probes

Procedure to match passive probe characteristics to oscilloscope channels for accuracy.

Calibrating Probes

4 Triggering

Auto and Normal Trigger modes

Explanation and comparison of Auto and Normal trigger modes.

Trigger Level Adjustment

Adjusting the trigger level for analog and digital channels.

Trigger Noise Rejection

Trigger Types

5 Displaying

AutoScale

Quickly configures the oscilloscope to best display input signals automatically.

6 Measurements and Math Functions

Making Automatic Measurements

Steps to make automatic measurements on channels or math functions.

Measurement Thresholds

Math Functions

Performing arithmetic and functional operations on acquired signals.

7 Printing and Saving

Saving Oscilloscope Data

Points about saving oscilloscope data to USB or internal memory.

To save a waveform and/or setup to a USB mass storage device

8 Acquisition Modes

To start and stop an acquisition

Instructions on how to start and stop data acquisition on the oscilloscope.

Averaging Mode

9 Web Interface

Setting up the Oscilloscope’s LAN Connection

Steps to configure the oscilloscope for network connectivity via LAN.

Accessing the Web Interface

Procedure to access the oscilloscope's web interface using a browser.

10 Serial Decode/Lister

Serial Decode

CAN Serial Decode

I2C Serial Decode

UART/RS232 Serial Decode

11 Mask Test

To create a mask from a “golden” waveform (Automask)

Procedure to create a mask from a golden waveform using the Automask function.

13 Digital Channels

To connect the digital probes to the device under test

Steps for connecting digital probes to the device under test.

Acquiring waveforms using the digital channels

To change the logic threshold for digital channels