Agilent Technologies InfiniiVision 5000 Series - Using the Analog Channels

Initial Setup 2
InfiniiVision Oscilloscopes User’s Guide 59
4 Press the Preview softkey to preview the screen saver you have selected with the
Saver softkey.
5 To view the normal display after the screen saver has started, press any key or turn any
knob.
Using the Analog Channels
1 Connect the oscilloscope probes for channels 1 and 2 to the Probe Comp output on the
front panel of the instrument.
2 Press the [1] key in the Analog section of the oscilloscope’s front panel to display the
Channel 1 Menu.
Channel
coupling
Invert
channel
Probe
menu
Trigger level
or threshold
Trigger
source
Channel,
Volts/div
Fine V/div
adjustment
Channel 2
ground level
Channel 1
ground level
Bandwidth
limit
Input
impedance