371
Agilent InfiniiVision 5000/6000/7000 Series Oscilloscope
User’s Guide
13
Digital Channels
To connect the digital probes to the device under test 372
Acquiring waveforms using the digital channels 375
To display digital channels using AutoScale 376
Interpreting the digital waveform display 378
To switch all digital channels on or off 379
To switch groups of channels on or off 379
To switch a single channel on or off 379
To change the displayed size of the digital channels 379
To reposition a digital channel 380
To change the logic threshold for digital channels 380
To display digital channels as a bus 381
Digital channel signal fidelity: Probe impedance and grounding 385
To replace digital probe leads 389
This chapter describes how to use the digital channels of a Mixed-Signal
Oscilloscope (MSO).
To Next Page
Loading...
