Serial Decode/Lister 10
InfiniiVision Oscilloscopes User’s Guide 295
CAN Serial Decode
1 Connect the CAN signal to one of the oscilloscope’s input channels.
2 Set up the trigger mode as described in “Triggering” on page 81. You can use CAN
trigger or another trigger type.
3 Select the CAN serial decode mode:
a Press the [Acquire] key.
b Press the Serial Decode softkey.
c In the Serial Decode Menu, press the Mode softkey.
d Use the Entry knob (or repeatedly press and release the Mode softkey) to select the
CAN serial decode mode.
For CAN triggering set up see page 98.
Display
decode
Decode
mode
Signal
setup menu
Return to
previous menu
Frame
counter
reset
Display
decode in
Lister
To Next Page
Loading...
