Agilent Technologies InfiniiVision 5000 Series User Manual

2 Initial Setup
52 InfiniiVision Oscilloscopes User’s Guide
Charging the Battery
When charging the battery, the operating temperature should be in the range from 0C to
45C,  80% relative humidity.
1 Connect the supplied AC adapter to the back of the oscilloscope, and connect the
adapter’s power cord to a suitable AC voltage source.
You can use the oscilloscope while the battery is being charged.
Operating with the Automotive Power Adapter Cable
The N5429A 12V DC automotive adapter cable is for charging and operating 6000A Series
Option BAT battery-powered oscilloscopes.
1 Connect the N5429A adapter cable to the back of the oscilloscope, and connect the
other end of the cable to a 12V DC automotive power source.
Battery Replacement
The battery (actually two batteries) can be replaced by a qualified technician. Refer to the
service guide for replacement instructions. The service guide is available on the CD that
was included with the oscilloscope at time of purchase, and at
www.agilent.com/find/6000manual.
Battery Warranty
The battery is warranted for a period of one year from date of purchase.
CAUTION
AC adapter for battery-powered oscilloscopes: Use only the supplied adapter.
Damage to the equipment could result if an improper AC adapter is used.
NOTE
If the battery charging indicator does not light
If the battery is extremely discharged, there may not be enough charge for internal
circuitry to cause the battery charging indicator LED to light. In this case, it can take up to
about 20 minutes of charging before the indicator will light.

Agilent Technologies InfiniiVision 5000 Series Specifications

General

Brand	Agilent Technologies
Model	InfiniiVision 5000 Series
Category	Test Equipment
Language	English