Agilent Technologies InfiniiVision 5000 Series - SPI Serial Decode

Serial Decode/Lister 10
InfiniiVision Oscilloscopes User’s Guide 323
SPI Serial Decode
1 Select the SPI serial decode mode:
a Press the [Acquire] key.
b Press the Serial Decode softkey.
c In the Serial Decode Menu, press the Mode softkey.
d Use the Entry knob (or repeatedly press and release the Mode softkey) to select the
SPI serial decode mode.
NOTE
Because of oscilloscope hardware resource limitations, you cannot decode SPI data
while CAN or LIN triggering is selected.
NOTE
For SPI triggering setup see page 150.
Display
decode
Decode
mode
Signal
setup menu
Return to
previous menu
SPI word
size
Display
decode in
Lister