Need help?Do you have a question about the Agilent Technologies 5000 Series and is the answer not in the manual?
General| Category | Oscilloscope |
|---|---|
| Display | Color LCD |
| Vertical Resolution | 8 bits |
| Input Coupling | AC, DC, GND |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Sample Rate | Up to 4 GSa/s |
| Channels | 2 or 4 |
| Input Impedance | 1 MΩ || 13 pF |
| Trigger Types | Edge, Pulse |
| Interface | USB, LAN |
Definitions of hazard levels (CAUTION, WARNING) and essential precautions.
Detailed safety warnings, cleaning procedures, and safety symbols.
Procedure to verify the accuracy of analog channel voltage measurements.
Steps to test the oscilloscope's frequency response using a signal generator.
Method to measure and verify the accuracy of the timebase oscillator.
Procedure to check the oscilloscope's ability to trigger at specified signal levels.
A template for documenting the results of performance verification tests.
Step-by-step instructions for performing the internal self-alignment routine.
Advice for resolving common oscilloscope operational issues.
Procedure to test the voltages supplied by the oscilloscope's power unit.
To Next Page
