Agilent Technologies E7495A RF User Manual

1
E7495A/B Manual Operation / Verification
E7495A/B Manual Verification
Manual Verification Procedures
The Manual verification procedures allow you to check out the
functionality of the major sections of the hardware that do not have
automated On-board Verification Tests.
Verifying the E7495A/B RF Functionality
Verifying the CW Source Functionality (Option 500/510 only)
Verifying the Complex Modulation Functionality (Option 510 only)
Verifying the Power Meter Functionality (Option 600 only)
Battery Management VerificationTests

Agilent Technologies E7495A RF Specifications

General

Frequency Resolution	1 Hz
Amplitude Accuracy	±1.5 dB
Input VSWR	< 1.5:1
Display Update Rate	up to 10 updates per second
Measurement Types	Spectrum analysis
Input Impedance	50 Ohm
Maximum Input Level	+30 dBm
Interface	GPIB, RS-232, USB
Power Requirements	100-240 VAC, 50/60 Hz

Summary

Verifying the E7495A/B RF Functionality

Verifying the CW Source Functionality (Option 500/510 only)

Verifying the Complex Modulation Functionality (Option 510 only)

Verifying the Power Meter Functionality (Option 600 only)

Battery Management Verification Tests

External DC Power Test

Verifies the Test Set operates on External DC Power by checking display icons and front panel LEDs.

Internal Battery Power Test

Verifies the Test Set operates on internal battery power by checking display icons and front panel LEDs.

Battery Charge Statistics

Verifies the test set's ability to control charge functionality and display battery data.

Battery Discharge Statistics

Verifies the test set's ability to switch between batteries and control discharge functions.