Replacing Assemblies 5
5000 Series Oscilloscopes Service Guide 93
Figure 25 Removing the display assembly
6 To reinstall the display:
a Align the top locating tab with the locating slot in the
sheet metal and the retaining hooks with their retaining
holes.
b Push down on the LCD until it is flat with the deck and at
the same time push the LCD to your left.
c Ensure the latch tab is seated in its hole as shown in
Figure 25.
d Route the cables down through the deck hole and
reconnect to the system board as shown in Figure 24.
Display (LCD)
Assembly
Latch Slot
Latch Tab
Deck
Retaining Hooks
To Next Page
Loading...
