Agilent Technologies 5000 Series User Manual

5000 Series Oscilloscopes Service Guide 5
Contents
Figures 9
Tabl es 11
1 Characteristics and Specifications 13
Power Requirements 14
Measurement Category 15
Measurement Category 15
Measurement Category Definitions 15
Transient Withstand Capability 16
Environmental Conditions 17
Specifications 19
Contact us 20
2Testing Performance21
List of Test Equipment 22
To verify voltage measurement accuracy 24
To verify bandwidth 28
To verify time scale accuracy 33
To verify horizontal Dt accuracy 35
To verify trigger sensitivity 38
Test Internal Trigger Sensitivity (all models) 40
Test External Trigger Sensitivity (2-channel models) 42
Test External Trigger Sensitivity (4-channel models) 45
Agilent 5000 Series Oscilloscopes Performance Test Record 48

Agilent Technologies 5000 Series Specifications

General

Category	Oscilloscope
Display	Color LCD
Vertical Resolution	8 bits
Input Coupling	AC, DC, GND
Power Supply	100-240 VAC, 50/60 Hz
Sample Rate	Up to 4 GSa/s
Channels	2 or 4
Input Impedance	1 MΩ || 13 pF
Trigger Types	Edge, Pulse
Interface	USB, LAN

Summary

Safety Notices

General Warnings and Precautions

Definitions of hazard levels (CAUTION, WARNING) and essential precautions.

Comprehensive Safety Instructions

Detailed safety warnings, cleaning procedures, and safety symbols.

Chapter 2: Testing Performance

List of Test Equipment

Voltage Measurement Accuracy Test

Procedure to verify the accuracy of analog channel voltage measurements.

Bandwidth Verification

Steps to test the oscilloscope's frequency response using a signal generator.

Time Scale Accuracy Test

Method to measure and verify the accuracy of the timebase oscillator.

Trigger Sensitivity Test

Procedure to check the oscilloscope's ability to trigger at specified signal levels.

Performance Test Record

A template for documenting the results of performance verification tests.

Chapter 3: Calibrating and Adjusting

User Calibration Procedure

Step-by-step instructions for performing the internal self-alignment routine.

Chapter 4: Troubleshooting

General Problem Solving Guide

Advice for resolving common oscilloscope operational issues.

Troubleshooting Flowchart

Checking Oscilloscope Power Supply

Procedure to test the voltages supplied by the oscilloscope's power unit.

Checking AC Input Board

Checking the System Board

Running Internal Self-Tests

Chapter 5: Replacing Assemblies

Removing the Cabinet

Removing the Front Panel Assembly

Removing the Main Shield

Removing the Display Assembly

Removing the System Board

Removing the Power Supply

Chapter 6: Replaceable Parts

Ordering Replaceable Parts

Replaceable Parts List