Agilent Technologies 5000 Series User Manual

77
Agilent Technologies
Agilent 5000 Series Oscilloscopes
Service Guide
5
Replacing Assemblies
To remove the cabinet 80
To remove the handle 81
To remove the storage lid 82
To remove the front panel assembly 83
To remove the keyboard assembly 86
To remove the main shield 89
To remove the display assembly 91
To remove the backlight inverter board and e-field shield 95
To remove the LCD, gasket, and protective lens from the display
mount 99
To remove the power shaft 102
To remove the AC input board 103
To remove the power supply 105
To remove the fan 106
To remove the system board 108
This chapter describes how to remove assemblies from the
Agilent 5000 Series oscilloscopes. After you have removed an
assembly, to install the replacement assembly, follow the
instructions in reverse order.
The parts shown in the following figures are representative and
may look different than what you have in your oscilloscope.
Tools Used for Disassembly
Use these tools to remove and replace the oscilloscope
assemblies:

Agilent Technologies 5000 Series Specifications

General

Brand	Agilent Technologies
Model	5000 Series
Category	Test Equipment
Language	English