Controls and Connectors 12
InfiniiVision Oscilloscopes User’s Guide 369
Rear Panel Control and Connector Descriptions
1. External Trigger Input See “External Trigger Input” on page 92 for an explanation
of this feature.
2. Trigger Output See “Trigger Output” on page 95.
3. 10 MHz Reference Connector See “Using the 10 MHz reference clock” on
page 406.
4. Calibration Protect Switch See “User Calibration” on page 394.
5. Digital Input Connector Connect the digital probe cable to this connector (MSO
models only).
6. XGA Video Output This video output is always active. You can connect an external
monitor to this connector.
7. USB Host Port This port functions identically to the USB host port on the front
panel. USB Host Port is used for saving data from the oscilloscope and loading software
updates. See also page 357.
8. USB Device Port This port is for connecting the oscilloscope to a host PC. You can
issue remote commands from a host PC to the oscilloscope via the USB device port. See
“Remote Programming with Agilent IO Libraries” on page 284.
9. LAN Port You can communicate with the oscilloscope and use the Remote Front
Panel feature using the LAN port. See “Web Interface” on page 275 and “Accessing the
Web Interface” on page 280.
10. Kensington Lock This is where you can attach a Kensington lock for securing the
instrument.
11. Power Connector Attach the power cord here, or on 6000A Option BAT models
attach power connector from 0950-4866 power supply.
12. GPIB Connector This port is for controlling the oscilloscope via GPIB. You can
issue remote commands from a host computer and retrieve data from the oscilloscope.
See “Remote Programming with Agilent IO Libraries” on page 284.
To Next Page
Loading...
Need help?
General
