7 Printing and Saving
246 InfiniiVision Oscilloscopes User’s Guide
• Form Feed — The Form Feed option can be selected to send a form feed command to
the printer after the waveform is printed and before the setup information is printed.
Switch Form Feed off if you want setup information printed on the same sheet of
paper with the waveform. This option only has an effect when the Setup Information
option is selected. Also, if the amount of setup information will not fit on the same
page with the waveform, it will be printed on a new page regardless of the Form Feed
setting.
•Landscape — Choose Landscape mode to print horizontally on the page instead of
vertically (portrait mode).
Palette
Press the Palette softkey to change the following options.
• Color — When Color printing is selected, the traces are printed in color.
•Grayscale — When Grayscale printing is selected, the traces are printed in shades of
gray rather than in color.
To Next Page
Loading...
