Agilent Technologies InfiniiVision 5000 Series - To Mount the Oscilloscope in a Rack; To Mount the 5000 or 6000 Series Oscilloscope in a Rack; To Mount the 6000 L Series Oscilloscope in a Rack

Initial Setup 2
InfiniiVision Oscilloscopes User’s Guide 43
To mount the oscilloscope in a rack
The InfiniiVision oscilloscopes can be mounted in an Electronic Industries Association
(EIA) standard 19-inch (487-mm) rack cabinet.
To mount the 5000 or 6000 Series oscilloscope in a rack
To mount the oscilloscope in a rack, purchase and install the N2916B rack mount kit.
Instructions are included in the kit. For details search for N2916B at www.agilent.com.
To mount the 6000L Series oscilloscope in a rack
The 6000L Series oscilloscope is supplied with all necessary hardware for installation
into a standard EIA 19-inch rack.
TOOLS REQUIRED (NOT SUPPLIED)
• #2 Phillips screwdriver
• T20 Torx driver
• T10 Torx driver
RACK MOUNT HARDWARE SUPPLIED
Quantity Description Agilent Part
Number
2 Front Extender Support D6104-01201
2 Rear Extender Support D6104-01202
4 Rear Extender Screw (M3 x 6 mm) 0515-0430
4 Dress Screw (10-32 x 0.0625) 0570-1577
8 Rail Screw (10-32 x 0.375) 2680-0281
12 Clip-nut (10-32) 0590-0804