4 InfiniiVision Oscilloscopes User’s Guide
In This User’s Guide…
This guide shows you how to use the InfiniiVision 5000/6000/7000 Series
oscilloscopes. It contains the following chapters and topics:
1 Introduction
Model numbers, options, where to find specifications.
2 Initial Setup
Unpacking and setting up your oscilloscope. Using the Quick Help system.
Using the analog channels, setting up the timebase.
3Connecting to the Device Under Test
Connect the oscilloscope to the device under test using passive or active
probes or 50-ohm BNC cables.
4Triggering
Trigger modes, trigger settings, and trigger types. Trigger noise rejection,
glitch capture.
5 Displaying
Stabilizing and interpreting the display, AutoScale. Using pan and zoom.
Adjusting display intensity, using infinite persistence, using labels. XGA
video output.
6 Measurements and Math Functions
Automatic time and voltage measurements, FFTs, math functions,
measurement statistics, cursor measurements, XY mode horizontal.
7 Printing and Saving
Printing the oscilloscope’s display, saving setups and data, and using the
file explorer.
8 Acquisition Modes
Run, Stop, and Single acquisitions. Selecting normal, average, peak detect,
or high resolution (smoothing) mode. About the Realtime option. Using
segmented memory.
To Next Page
Need help?
General
