2 Initial Setup
44 InfiniiVision Oscilloscopes User’s Guide
1 Loosely attach the Front Extender Supports to the Rear Extender Supports with four
(4) clip-nuts and four (4) of the 10-32 x 0.375 Rail Screws. (The screws require a Torx
T20 driver.) Choose the correct set of slots in the supports such that their overall
length is approximately correct for the depth of your cabinet.
2 Fasten the Rack Mount Extenders to the oscilloscope chassis with the four (4) M3 x 6
mm screws, using a Torx T10 driver as follows:
Step 1,
step 5
Step 2
If needed
If needed
Step 4
Step 3
To Next Page
Loading...
