Chapter 4 Retrofitting Options
To Retrofit A5 DC Power Input Assembly (Option 002)
4-6 Assembly-Level Service Guide
4
5 Now, re-install the front bezel by performing the front bezel removal procedure,
in Chapter 3 of this guide, in reverse. Be sure to insert A2 Display Board’s cable
into connector J6 on A1 Motherboard Assembly.
6 Tighten the three H1 screws, shown in Figure 4-1A, to secure the motherboard to
the chassis.
Figure 4-1B. DC Power Input Assembly Retrofitting
H2
H2
H1
J18
A4 AC Power Supply
Assembly
To Next Page
Loading...
