83
Agilent 6400 Series Triple Quadrupole LC/MS System
Installation Guide
5
Other Setup Tasks
To start the Data Acquisition program 84
To stop MassHunter Engines 84
To stop MassHunter processes in case of unrecoverable errors 85
To view the log book 85
To configure the network interface card 87
To remove the MassHunter Workstation software 88
To reconfigure the instrument 89
To confirm the collision cell gas flow rate (6470A and 6495A/B only) 91
This chapter contains tasks that are related to setting up your Triple
Quadrupole LC/MS.
For complete information on using the your Triple Quadrupole LC/MS, refer to
the list of resources found in the Quick Start Guide.
To Next Page
Loading...
Need help?
General
