Command Summary
109
C
Command Summary
Introduction
For convenience, a “quick reference” listing tabulating general command headers, and calibration command headers is
shown at the beginning of Table C-1 (page 110). (Note that calibration commands are described in detail in Appendix A.)
Table C-2 (pages 111-115) provides an alphabetical listing and a brief description of each command that may be sent to the
power supplies. Chapter 5 gives a complete description (including syntax) of most of the commands listed.
All of the commands can be executed remotely over the GP-IB. Many of the commands may also be executed locally from
the supply's front panel (marked by single asterisks in Table C-1).
Several commands will generate a response which will be indicated on the front panel of the supply. These commands are
indicated by double asterisks in Table C-1.
Command headers are accepted in upper or lower case letters although only upper case letters are used in this summary.
The brackets < > indicate a number to be sent.
Note that <ch> must specify an output channel number from 1 through 4 as applicable. Commas or spaces are required
between numbers. Spaces are optional between the command header and the first number. Use semicolons between
multiple commands sent in one statement.
To Next Page
Loading...
Need help?
General
