Hardkey and Softkey Reference ESG Family Signal Generators
Save
4-94 User’s Guide
Save Seq[n] Reg[nn]
Press this softkey to save the current instrument state in the specified
register and sequence. The instrument state includes all of your setup
selections except list and step sweep data and functions which are
identified in this manual as persistent states. Do not press this softkey
until you have specified the correct sequence and register using the
Select Seq and Select Reg softkeys. For example, if you want to save to
register 5 in sequence 4, press
Select Seq. The currently selected
sequence is displayed in the active entry area. Change the number to 4
using the up and down arrow keys, the front panel knob, or enter a 4
using the numeric keypad and press the
Enter terminator softkey.
Sequence 4 is now displayed in all softkeys which specify a sequence in
this menu. Now, to select register 5, press
Select Reg. The currently
selected register is displayed in the active entry area. Change the
number to 5 in the same way that you changed the sequence number.
Register 5 is now displayed in all softkeys which specify a register in
this menu. Now press
Save Seq [4] Reg[05] and the current instrument
state will be stored in register 5 of sequence 4. There are 100 registers
available (0 through 99) in each of 10 (0 through 9) sequences. You can
use these registers in any combination so long as the total number of
registers used does not exceed 100.
Softkey Location:
Save > Save Seq[n] Reg[nn]
Select Reg
Press this softkey to choose a register for all softkeys which specify a
register in this menu. For example, if you want to select register 5,
press
Select Reg. The currently selected register is displayed in the
active entry area. Change the number to 5 using the up and down
arrow keys, the front panel knob, or enter a 5 using the numeric keypad
and press the
Select Reg terminator softkey. Register 5 is now displayed
in all softkeys which specify a register in this menu.
You can also use this softkey to select a register and save the current
instrument state to that register. For example, if you want to select and
save to register 6, press
Select Reg. The currently selected register is
displayed in the active entry area. Change the number to 6 using the
numeric keypad and press the
Save Reg terminator softkey. Register 6 is
now displayed in all softkeys which specify a register in this menu and
the current instrument state has been saved to register 6.
There are 100 registers available (0 through 99) in each of 10 (0 through
9) sequences. You can use these registers in any combination so long as
the total number of registers used does not exceed 100.
Softkey Location:
Save > Select Reg
To Next Page
Loading...
Need help?
General
