17 Utility
17.5 ForcePG: PG OutputX (A.01.20)
[Supported Analyzer]
B1500A, B1505A, 4155B, 4155C, 4156B, 4156C
[Description]
Sets Output1 or Output2 of Agilent 81110A Pulse Generator, and triggers it. Pulse leading/trailing edge
transition time can be set.
Execute ResetPG to stop pulse output before the specified pulses are applied.
[Required Modules and Accessories]
Agilent 81110A Pulse Generator (2-output, PGU1 and PGU2)
GPIB cable
[Test Parameters]
Address: GPIB address of Agilent 81110A Pulse Generator
SelectPort: Pulse output port
Period: Pulse period [s]
Delay: Pulse delay time [s]
Width: Pulse width [s]
LeadTime: Pulse leading edge transition time [s]
TrailTime: Pulse trailing edge transition time [s]
Level: Pulse High level [V]
Base: Pulse Low level [V]
ExtImp: Load impedance [ohm]
NoOfPulse: Number of output pulses
Agilent EasyEXPERT Application Library Reference, Edition 8
17-7
To Next Page
Loading...