Agilent Technologies G7129C User Manual

Agilent InfinityLab LC Series Vialsamplers User Manual 154
4 Preparing the Module
Setting up the Vialsampler
Setting up the Vialsampler
The setup of the Vialsampler is shown with the Agilent OpenLab ChemStation
C.01.07. Depending on the controller (e.g. Agilent Local Controller, OpenLab
EZChrom, Masshunter) the screens look different.
Figure 29 ChemStation Method and Run Control
After successful load of the OpenLab ChemStation, you should see the module
as an active item in the graphical user interface (GUI).
NOTE
This section describes the Vialsampler settings only. For information on the
software or other modules refer to the corresponding documentation.

Agilent Technologies G7129C Specifications

General

Category	Laboratory Equipment
Manufacturer	Agilent Technologies
Model	G7129C
Temperature Range	4 to 40 °C
Type	Gas Chromatograph
Flow Rate Range	0.1 to 10 mL/min
Detector Type	Not applicable
Data Output	LAN
Power Requirements	100–240 V, 50/60 Hz
Dimensions	345 mm (W) x 440 mm (D) x 230 mm (H)