Setup Instructions
ELECTRICAL SHOCK HAZARD WARNING: Electrical shock may occur when plugging
the Immerse™ optional air pump into the wall outlet. Use ONLY grounded or hospital-
grade outlets.
Immerse™ can be placed on any conventional medical bed, including those used in hospitals, nursing
homes or a homecare. The original mattress should be removed and stored in an appropriate place. The
following steps should be completed in installing the system:
1. Remove standard mattress from bed.
2. Replace with Immerse™ mattress. (Be sure air hoses are at the foot end of the bed).
3. Strap Immerse air mattress to bed frame on all four sides with straps provided.
4. Place control unit on the footboard using the two hinged hooks located on the back of the unit.
5. Use power cord to connect the control unit and medical grade power outlet.
6. Align master shape on mattress quick connector to same shape on control unit.
7. Apply upward pressure and twist counterclockwise until all three tabs are seated in slots.
8. Visually inspect connection to ensure connector will not leak air.
IFU0000073 Immerse User Manual
To Next Page
Loading...