agiliti Immerse - Troubleshooting; Problem Diagnosis and Solutions

Troubleshooting
ELECTRICAL SHOCK HAZARD WARNING:
To avoid electrical shock, DO NOT open
the control unit. Refer servicing to qualified personnel only.
CAUTION: Only authorized personnel should engage in the troubleshooting process.
Troubleshooting by unauthorized persons could result in personal injury or equipment
damage.
NOTE: If troubleshooting process does not solve the problem, please contact an Agiliti representative
for further assistance.
Problem Troubleshooting
Mattress not inflating
— Check that the hoses are not punctured, kinked or
disconnected.
— Check for proper connections from the hoses to the control
unit. Make sure they are secure.
— Check air filters on back of control unit and clean if
necessary.
— Ensure CPR function is in the closed position.
Power loss
— Check the ON/OFF switch.
— Check power cord for any damage.
— Unplug the Control Unit and check fuses located near the
main ON/OFF switch. Replace fuse/s as necessary.
— Ensure unit is plugged into a working power outlet.
Reduced air flow
—
Check for possible obstructed/contaminated foam filter.
Replace as necessary.
— Check for possible obstructed/contaminated HEPA filter.
Replace as necessary.
Excessive control unit
noise
—
Check for possible obstructed/contaminated foam filter.
Replace as necessary.
— Check for possible obstructed/contaminated HEPA filter.
Replace as necessary.
Odor
—
Check for excessive contamination on HEPA filter. Replace
as necessary.
Fuses
— To open: insert flat head screwdriver into the center slot and turn counterclockwise.
28
IFU0000073 Immerse User Manual