Operating Instructions
CPR Function
1. CPR Function (Push Button or Dial) is located on the front center of the control unit.
a. CPR button
i. Press and release the CPR button (illustration below) to activate the CPR function. -CPR
alarm and light will come on. After 10 seconds the alarm will beep every 5 seconds and
the light will start flashing-.
ii. Press and release CPR button again to exit; control unit will return to the previous mode
of operation.
b. CPR Dial (bel
ow)
i. Turn the Control Unit’s CPR Dial clockwise to the CPR ON position.
ii. After mattress deflation is complete, turn off the Control Unit.
IN THE EVENT THE ALARM SOUNDS, THE INDICATOR LIGHT WILL APPEAR INDICATING
EITHER POWER FAILURE OR LOW PRESSURE. SEE THE TROUBLESHOOTING SECTION
INDICATED IN THE TABLE OF CONTENTS.
IFU0000073 Immerse User Manual
To Next Page
Loading...