How to fix the unclear image on AGM Global Vision RATTLER TS19-256?
To address an unclear image on your AGM Global Vision Thermal cameras, perform the sight adjustment referring to section 2.1.
What to do if my AGM Global Vision RATTLER TS19-256 scope fails to activate?
If your AGM Global Vision Thermal camera scope fails to activate, it might be due to missing or improperly installed batteries. Ensure the batteries are correctly inserted. Another cause could be dead batteries, so try replacing them. Also, check for dirty or corroded batteries, surfaces, or contacts and clean them.
Why capturing or recording fails on my AGM Global Vision RATTLER TS19-256 Thermal cameras?
If your AGM Global Vision Thermal cameras capturing or recording fails, it could be due to several reasons. First, check if the device is connected to your PC, as this disables capturing and recording. Also, the storage space might be full, or the device may be in a low-battery condition.
Why does my AGM Global Vision Thermal cameras scope shut off after shot?
General| Resolution | 256x192 |
|---|---|
| Frame Rate | 50 Hz |
| Battery Life | Up to 4.5 hours |
| Objective Lens | 19 mm |
| Refresh Rate | 50 Hz |
| Pixel Pitch | 12 μm |
To Next Page
