Agora Models Bismarck - Page 14

06
Pressing button S3 on the tester box
18-01 (inset below) turns on the LEDs
of the two searchlights on the aft
superstructure. End the test by
pressing button S3 again.
Button S4 on the tester box 18-01
(inset below) rotates the range finder
on the aft control station. End the test
by pressing the S4 button again.
Completed work
The aft superstructure electronics
have been connected and tested.
After completing the tests, turn
off the battery box and carefully
remove the tester cable from
port 11 of the aft circuit board.
09
07
14
13
AGORAMODELS BISMARCK
14
AGORAMODELS BISMARCK