5
TERMINOLOGY USED IN THE MANUAL
1. Warning: This term means that there is a risk of physical harm or death to the operator or people
nearby.
2. Caution: This term means that there is a risk of damage to the machine, cutting tool or other
equipment
3. Note: This terms offers useful information relating to the operation of the machine or its
maintenance.
SPECIFIC SAFETY RULES
Magnetic mounting can release, so always use a Safety Strap.
1.
The magnet’s adhesion depends on the thickness of the work piece. Always ensure that the work
piece is a minimum of 12mm (7/16 in.) thick. If it is not, then use a piece of steel plate at least 12mm thick
and larger than the magnet below the workpiece to supplement the magnetic adhesion.
2.
Metal chips and other debris will seriously hamper magnetic adhesion. Always ensure that the
magnet is clean.
3.
Other units used on the same receptacle will cause uneven voltage which could lead to the magnet
releasing. Always use the tool alone on the receptacle.
4.
It is hazardous to use the drill upside-down. Do not exceed 90 degrees from horizontal.
SYMBOLS USED IN THIS MANUAL
V…….......volts
A…….......amperes
Hz……......hertz
W……......watt
~………....alternating current
n
0
………..no load speed
min
-1
…......revolutions or reciprocation
per minute
.......warning of general danger
.…with electrical earth
......read these instructions
......always wear eye protection
......always wear a dust mask.
.....always wear hearing protection
.....wear safety-approved hard hat
.....Keep hands clear – pinching hazard.
DANGER! Keep hands away from cutting area and
the blade.
Rotating parts - entanglement hazard. Keep
hands, loose clothing and long hair away
from moving parts
Do not dispose of electric tools,
accessories and packaging together
with household waste material
To Next Page
Loading...