AGPtek RG109MAX - Pre-flight Preparation; Flight Environment Guidelines; Blade Replacement Procedure; Important Product Notes

󾙓 󾙓
󾙔 󾙔
Pre-flight preparation
flight environment
indoor: Spacious space away from obstacles,
crowds or pets are preferred.
Please keep the UAV in line of sight and away
from obstacles, high-voltage cables, trees and
personnel during the flight.
Do not fly in extreme environments, such as
heat, cold, strong wind or heavy rain.
Outdoor: Sunny, windy and sunny weather
are preferred.
Fan blade B
Fan blade A
Subject
Power switch
Wifi camera
Boom
Electric machine
Blade replacement:
When flying, the fan blade A rotates clockwise,and the fan blade B rotates counterclockwise.
1.
2.
1. lmportant note
This product is not a toy, wrong use will cause damage.
Please follow the instructions before using this product. Do not disassemble the product yourself. Otherwise, the man facturer is not
responsible for any damage.
Warning: lt is necessary to fly in a safe area or away from others, and do not control the aircraft above a dense crowd. Due to the pilot’s
operation error or wireless interference in the operation process, accidents and failures are easy to cccur, and damage or injury to the
crowd is easy to occur.
Prohibition: Especially for indoor and outdoor fight, please keep away from obstacles This product is suitable for both indoor and
outdoor flight (wind strength not more than 4). Please choose a place that is free from obstacles, crowds and pets, passers-by, such as,
heating scurce, heat source, electric wires or electronic power source will not collide with the drone ,landing, entanglement, or cause fire,
electrocution and damage to life and property.
Warning: As this product is mainly suitable for people over 14 years old, it may be difficult to learn at first, we recommend you to ask an
experienced pilot for guidance.
2. Safety instructions
The fan blade to be replaced must be replaced corresponding to the relative position on the machine.
Fan blade A needs to be installed at position A, and fan blade B needs to be installed at position B.
lf fan blade is replaced incorrectly. it can not be controlled.
-2-